Avdio kabel 3,5 mm vtič / 2x RCA vtič 3 m InLine 99243

Space-saving slim design:The extra-thin and flexible cable allows for easy installation even in confined spaces and cable ducts.
Reliable stereo signal transmission:3-pin assignment for clean analogue transmission of left and right audio channels via 3.5 mm jack to 2x RCA.
Gold-plated contacts:Low-corrosion contact surfaces ensure stable signal transmission over the long term.
Robust metal plugs:Nickel-plated plug housings offer mechanical stability and a durable connection.
Flexible length availability:Variants from 0.5 m to 10 m enable installation solutions tailored to your needs.

The InLine® Slim Audio Cable with 3.5 mm jack plug to 2x RCA plug is suitable for analogue stereo audio transmission between playback devices and audio amplifiers. The 3-pin stereo assignment enables separate transmission of the left and right channels.
The extra-thin slim design makes the cable easy to install, even in confined spaces. Its high flexibility makes it easy to lay behind furniture, in racks or within cable management systems.
Gold-plated contacts support permanently stable signal transmission. The nickel-plated metal plugs ensure mechanical stability and a reliable connection, even with frequent plugging and unplugging.
With lengths ranging from 0.5 m to 10 m, the range covers a variety of installation requirements and offers a suitable solution for both short patch connections and longer distances.

Connector 1: 3.5 mm jack plug
Connector 2: 2x RCA plugs (red/white)
Signal type: analogue stereo audio signal
Assignment: 3-pin
Contacts: gold-plated
Plug housing: nickel-plated metal
Design: slim, extra thin and flexible
Available lengths: 0.5 m, 1 m, 2 m, 3 m, 5 m, 10 m

InLine Slim Audio Cable 3.5mm male / 2x RCA male 3m. Connector 1: 3.5mm, Connector 1 gender: Male, Connector 2: 2 x RCA, Connector 2 gender: Male, Cable material: Copper, Connector contacts plating: Gold, AWG wire size: 26, Cable length: 3 m, Product colour: Black

How to use

Insert the 3.5 mm male plug into the headphone or line output of your source device. Connect the two RCA male plugs to the corresponding left (white) and right (red) RCA inputs on the amplifier, receiver or powered speakers. Ensure connectors are fully seated to avoid channel loss. Route the cable to avoid sharp bends and keep it away from power cables to reduce interference.

Recommendations

For best performance, avoid tightly coiling the cable and prevent repeated sharp kinks. If using in a permanent installation, check that RCA polarity (left/right) is correct and place the cable away from high-voltage lines to minimise hum and noise.