Avdio kabel 3m Omnitronic 30225157

The Omnitronic 30225157 audio cable is a 3-meter connection lead combining a single 3.5 mm male jack with two 3-pin XLR male connectors. Designed for linking portable devices, mixers and professional audio equipment, this black cable provides a straightforward, balanced-signal-ready interface for transmitting stereo or split-channel audio from a headphone or line output to microphone/line inputs on PA systems and mixers.

Advantages

This cable offers a practical length of 3 m that balances reach and signal integrity while remaining manageable on stage or in studios. The combination of a 3.5 mm jack and two XLR male connectors enables direct connection from consumer devices to professional audio gear without adapters. Robust connectors and a durable jacket contribute to reliable performance and longer service life in daily use situations.

Suitable for

Key specifications

How to use

Insert the 3.5 mm male plug into the headphone or line output of the source device. Connect each XLR male connector to the corresponding left and right XLR inputs on the mixer or PA system, ensuring channels are matched to maintain correct stereo orientation. Secure connections by seating connectors fully; no additional configuration is required for passive signal transfer. When disconnecting, grasp the connector housings rather than pulling the cable to avoid damaging the terminations.

Recommendations

For best results, keep cable runs as short as practical and avoid running alongside mains power cables to reduce potential interference. Use appropriate gain staging on the receiving device to prevent clipping and, when using unbalanced source outputs, verify signal levels and polarity to ensure correct channel separation.