DMX kabel PSSO 3022783A IP65 3-pinski 1,5 m

PSSO DMX cable 3022783A is a 3‑pin DMX lead with IP65 protection and a 1.5 m length, created for reliable digital lighting control connections in both indoor and outdoor environments. The cable features a compact 3‑pin connector arrangement compatible with standard DMX512 fixtures and controllers where a weather‑protected interface is required. Its IP65 rating ensures protection against dust ingress and low‑pressure water jets or splashes, making the cable suitable for temporary outdoor use and damp conditions without additional sealing.

Advantages

The IP65 construction provides dust resistance and splash protection, reducing the risk of connection failure in exposed locations. A 1.5 m length offers a balance between flexibility and neat cable runs for stage and event setups. The 3‑pin connector delivers a simple, widely supported interface for DMX512 control circuits, while build quality focuses on secure mating and reliable signal transmission in typical lighting control applications.

Suitable for

Key specifications

How to use

Connect the 3‑pin DMX cable between the DMX output of a controller and the DMX input of a fixture or between fixtures to form a control chain. Ensure connectors are fully engaged and hand‑tightened as applicable to maintain IP65 protection at connection points. Route the cable avoiding sharp bends, crush points and sources of excessive heat. For longer runs or complex systems, maintain correct DMX termination and addressing practices as required by the lighting system.

Recommendations

When used outdoors, verify that connector seals and mating faces are clean and free of debris before assembly. Do not submerge the cable or rely on IP65 protection for permanent immersion; for continuous underwater or fully submerged applications, select a higher protection rating. For reliable long‑term operation, inspect connectors and cable jacket regularly for wear and replace if damage is found.