InLine 40 kosov Bulk-Pack patch kabel S/FTP PiMF Cat.6 250MHz PVC baker

The InLine B-76402 40pcs S/FTP Cat.6 2m patch cable pack contains forty identical 2-meter cables designed for structured cabling and everyday network connections. Each cable uses S/FTP (shielded foil around pairs with overall braid) construction to minimize electromagnetic interference and supports data transmission up to 250 MHz. The cables are terminated with RJ-45 connectors on both ends and are sheathed in a grey PVC jacket for durability and easy identification in racks and cabling runs.

Advantages

S/FTP shielding with pair-insulated foil and an overall braid reduces crosstalk and external interference, improving signal integrity in environments with multiple cables or electrical noise. Support for Cat.6 performance up to 250 MHz enables reliable Gigabit Ethernet and other high-speed network applications. The 2 m length offers a practical balance between reach and cable management for patch panels, wall outlets and office equipment. A grey PVC jacket provides mechanical protection while maintaining a neutral, professional appearance.

Suitable for

• Connecting switches, patch panels and routers within racks and comms cabinets
• Desk-to-wall outlet connections for workstations and VoIP phones
• Small office and home network installations requiring Cat.6 performance
• Temporary or permanent cabling where reduced interference is needed

Key specifications

• Cable category: Cat.6 (S/FTP)
• Frequency rating: up to 250 MHz
• Length per cable: 2 m
• Connector type: RJ-45 to RJ-45
• Shielding: foil around each pair (PiMF) plus overall braid
• Jacket material: PVC
• Colour: grey
• Quantity in pack: 40 cables

How to use

Insert one RJ-45 connector into the network port of a switch, router or wall socket and the other end into the device to be connected, ensuring secure, full insertion until the connector latch clicks. Route the cable to avoid tight bends and keep it separated from power lines and other sources of electromagnetic interference where possible. For rack installations, use suitable cable management to maintain bend radius and reduce stress on connectors. Test connections after installation using network testing tools to verify continuity and performance.

Recommendations

For best results, avoid bending the cable sharply near the connector, do not exceed typical installation bend radii, and keep the cable run away from high-voltage power cables. When using multiple cables in parallel, maintain proper cable management and grounding of equipment to preserve shielding effectiveness and achieve consistent Cat.6 network performance.