InLine patch kabel SF/UTP Cat.5e AWG26 CCA PVC siv 100m

Patch Cable InLine Cat.5e 100m SF/UTP AWG26 CCA PVC Grey is a twisted-pair Cat.5e network cable supplied in a 100 m hank. The cable uses SF/UTP shielding and AWG26 conductor size; conductors are made from a copper-clad aluminium (CCA) alloy. It is intended for on-site patching to custom lengths and general network cabling where Cat.5e performance is required.

Advantages

The SF/UTP design provides screening to reduce external interference while the AWG26 conductors offer a compact diameter suitable for cable runs and patching. Supplied as a 100 m hank, the cable allows cutting to length for custom installations. The grey PVC jacket gives basic mechanical protection and easy visual identification.

Suitable for

• Short to medium-length Ethernet patch runs
• On-site cutting and termination to specific lengths
• Basic office and home network installations where Cat.5e is sufficient

Key specifications

• Cable type: Twisted pair Cat.5e SF/UTP
• Length: 100 m
• Conductor: CCA (copper-clad aluminium)
• Wire gauge: AWG26
• Outer jacket: PVC, colour grey
• Connectors: none (sold as bulk cable for termination)

How to use

Measure and cut the required cable length from the 100 m hank. Strip the outer jacket and individual pairs carefully, then terminate with appropriate RJ45 plugs or punch-down keystone jacks following Cat.5e wiring standards (T568A or T568B). Ensure SF/UTP shielding is properly grounded when using shielded connectors or panels.

Recommendations

For reliable high-speed links over longer distances (for example more than approx. 50 m), use a 100% copper (CU) Cat.5e or higher-rated cable; CCA conductors may not guarantee full Category 5e performance under extended-run conditions.