Meč žage masivni Einhell 4500363 25 cm

The Einhell 4500363 25 cm solid chainsaw bar is designed as a direct replacement bar for compatible Einhell chainsaws. At 25 cm cutting length and a weight of approximately 410 g, the bar is constructed for strength and steady guidance of the cutting chain. Its solid build supports consistent chain alignment and contributes to smoother, more precise cuts on wood and similar materials.

Advantages

This solid chainsaw bar offers a compact 25 cm cutting length that balances maneuverability with cutting capacity for small to medium tasks. The robust construction improves durability under regular use and helps maintain chain tension. Its lightweight design reduces added front-end mass on the saw, contributing to easier handling and reduced operator fatigue during extended work periods.

Suitable for

• Pruning and trimming branches and small trees
• Cutting firewood and small logs
• Garden and landscape maintenance tasks
• Replacement for worn or damaged bars on compatible Einhell chainsaws

Key specifications

• Bar length: 25 cm cutting length
• Approximate weight: 410 g
• Compatibility: designed for use with compatible Einhell chainsaw models
• Construction: solid single-piece bar for chain guidance and stability

How to use

Before installation, make sure the chainsaw is switched off and the battery or spark plug is disconnected. Remove the side cover and old bar and chain according to the chainsaw manufacturer’s maintenance instructions. Fit the Einhell 25 cm bar into the guide slot, position the chain around the bar and sprocket, then reattach the side cover. Set initial chain tension following the specified tension procedure and rotate the chain manually to check for smooth movement. After installation, perform a short test cut on a suitable timber piece and recheck chain tension and lubrication.

Recommendations

For safe and efficient operation, use the chainsaw bar with the correct chain pitch and gauge specified for your Einhell chainsaw model, maintain proper chain tension and lubrication, and follow all safety instructions from the chainsaw manufacturer. Regularly inspect the bar for straightness and wear, and replace it if excessive wear or damage is observed.