Patch kabel VALUE S/FTP (PiMF) Cat.6 siv 1 m

VALUE S/FTP (PiMF) Cat.6 patch cord, 1 m long, with RJ45 connectors on both ends. The cable is constructed from 8 AWG-26 copper conductors and features S/FTP (pair in metal foil) shielding to reduce crosstalk and external interference. Contact wiring is 1:1 according to EIA/TIA 568A, suitable for use as a patch cable in a wiring cabinet or as a direct connection between devices. The flexible jacket allows narrow bending radii from approximately 3 cm.

Advantages

The S/FTP (PiMF) construction provides improved protection against electromagnetic interference compared with unshielded cables, while AWG-26 copper conductors maintain reliable signal transmission. RJ45 connectors on both ends make the cord ready for immediate use in standard network installations. Its 1 m length is convenient for short connections in patch panels, switches and devices.

Suitable for

• Patch connections in wiring cabinets and patch panels
• Direct device-to-device connections (switches, routers, PCs)
• High-speed Ethernet up to 1000 Mbit/s (Gigabit Ethernet)

Key specifications

• Brand: VALUE
• Type: S/FTP (PiMF) Cat.6 patch cord
• Length: 1 m
• Connectors: RJ45 — both ends
• Conductors: 8 wires, AWG-26 copper
• Wiring: 1:1, EIA/TIA 568A
• Impedance: 100 Ω
• Colour: grey
• MPN: 21.99.0801
• EAN: 7611990174713

How to use

Plug each RJ45 connector into the corresponding network port on devices or into patch panel/switch ports. Ensure connectors are fully inserted until they click. For best performance, avoid sharp bends and excessive pulling; maintain the recommended minimum bend radius of about 3 cm. Use the 1 m length for short links within racks or between adjacent devices.

Recommendations

For optimal shielding performance, connect both ends to grounded equipment or to shielded patch panels where available. Avoid routing the cable parallel to high-voltage power lines to reduce potential interference.